Kreg PRS1025 Precision Router Table Top Manual de usuario descargar pdf (Pagina 5)

The table top (1) is shipped with the combination miter-gauge track/

T-track (2) in place, but fastened only with a plastic rivet. Remove

the rivet and secure the track with the system screws (3), driving them

into the holes in the table top.

Assemble the top

Turn the table top upside down. Align the two support struts (4) with

holes in the bottom of the table top. Drive ¾" coarse-thread screws

(5) with the driver bit (6).

Assembly

Position an insert-plate leveler (7) in each corner of the table-top

opening. The holes in the levelers align with holes in the table-top.

Fasten the levelers to the tabletop with 1¼" coarse-thread screws (8).

Using the hex wrench (9), drive a set screw (10) into the outside

holes in each leveler, threading them in from the bottom until the

tips are ⅜" below the table surface.

ATTENTION In this step, use the ¾" screws (5), NOT the 1¼"

screws (8).

1 2 3 4 5 6 7 8 9 10 ... 19 20

Sin comentarios

Kreg PRS1025 Precision Router Table Top Manual de usuario Pagina 5